Samsung iDCS 500 Manual page 13

Printed circuit cards

Hide thumbs Also See for iDCS 500:

3-12

Chapter 3

Installing Printed Circuit Cards

MISC BOARD

This board has no selectable options and installs in position LOC3 of the MCP card when the system

has one cabinet installed

must be installed in position LOC2 of the SCP card

Up to 3 MISC boards can be installed in a system (one on the MCP or SCP and one on each LCP).

The MISC board is required to provide external music inputs, external page outputs and

programmable relay contacts. To install the MISC board remove the two (2) screws holding the MCP

or LCP protective casing together

(see Figure 3-10)

connectors, taking care to properly line them up and press gently on the back of the board to seat it.

The MCP/LCP/SCP case can now be reassembled if all required daughter boards have been installed.

. If the system has more than one cabinet the MISC board

(see Figure 3-1)

(see Figure 3-6)

and separate the two halves of the case. Place the MISC board face down over the two

Figure 3-9 MISC Board

Figure 3-10 Processor Card Screw Location

or position LOC2 of the LCP cards.

(see Figure 3-3)

or remove the 4 screws holding the SCP case together

Table of Contents