Lan Board - Samsung iDCS 500 Manual

Printed circuit cards

Hide thumbs Also See for iDCS 500:

LAN BOARD

This board has a switch S1 for memory back up and installs in position LOC3

MCP card when the system has more than one cabinet installed or in position LOC2 if the system is

going to require a MISC board in a single cabinet system with M version software. The LAN board is

required to expand the system memory, to provide SIO ports 3 and 4, and a 10BASE-T LAN interface

processor. To install the LAN board remove the two (2) screws holding the MCP protective casing

together

(see Figure 3-6)

the three connectors, taking care to properly line them up and press gently on the back of the board to

seat it. The MCP case can now be reassembled if all required daughter boards have been installed.

NOTE: Do not forget to turn on the memory backup switch on the LAN board before installing it on

the MCP

and separate the two halves of the case. Place the LAN board face down over

(see Figures 3-1 and 3-8)

Figure 3-8 LAN Board

3-11

of the

(see Figure 3-1)

Memory Backup

Switch

Table of Contents