The Stapling Position Is Not Correct; Other Problems; Preview Images Or Thumbnail Images Do Not Appear; The Touch Panel Screen Is Difficult To View - Sharp MX-C381 Operation Manual

Problem
Stapling does not take
place.
The stapling position
is not correct.

OTHER PROBLEMS

Problem
Preview images or
thumbnail images do
not appear.
The touch panel
screen is difficult to
view.
You were logged out
without having
performed logout
yourself.
Point to check
Is a different width of paper mixed in?
Are there more sheets than can be
stapled at once?
Is a paper size that cannot be stapled
included in the print job?
Is the paper type setting of the tray
selected in the printer driver set to a
paper type that cannot be stapled?
Have functions been disabled by the
administrator?
Is the stapling position set correctly?
Point to check
Are there a number of jobs waiting to be
executed?
Is the display contrast properly
adjusted?
Did Auto Clear activate?
Stapling is not possible when paper of different widths
are mixed together. To perform mixed size stapling, use
paper of the same width. When copying, select [Mixed
Size Original] in the special modes.
For the maximum number of sheets that can be stapled,
see "SPECIFICATIONS" in the Maintenance & Safety
Guide.
For the paper sizes that can be stapled, see
"SPECIFICATIONS" in the Maintenance & Safety
Guide.
Check the paper type settings in the machine and select
a tray that has paper that can be used for stapling*.
Click the [Tray Status] button in "Paper Selection" on
the [Paper] tab of the printer properties window and
check the paper type setting of each tray.
* Stapling is not possible on labels, transparency film, or
envelopes. In addition, if "Disable Staple" is selected in the
user type, stapling will not be possible.
Some functions may have been disabled in the system
settings (administrator). Check with your administrator.
Check the stapling position setting.
☞
2. COPIER "OUTPUT" (page 2-34)
Wait until several of the jobs have been executed.
Touch the brightness adjustment key (
system bar in the touch panel to adjust the brightness.
☞
1. BEFORE USING THE MACHINE
BAR" (page 1-12)
When user authentication is used, the currently logged
in user will be automatically logged out if Auto Clear
activates. (Except when in PC scan mode.)
Log in again.
If you are the administrator, you can change the time
setting of Auto Clear or disable Auto Clear in "Auto
Clear Setting".
➞ System Settings (Administrator) > "Operation
Settings" > "Other Settings" > "Auto Clear Setting"
8-38
TROUBLESHOOTING
Solution
Solution
) on the
"SYSTEM
Contents