Date - Bard FUSION-TEC WR Series Literature Assembly

Jobsite Startup and Commissioning Report
Shelter (Name/Number):
Commissioned By (Name):
Installation By (Company):
Installer Address/Phone No.:
Date Commissioned:
Shipping Inspection – Inspect each unit for the following:
Yes No Do any of the units have visible damage from falling over during transit?
Yes No Are any of the Condenser Coils located at the upper front of each unit Damaged?
Yes No Are any of the Condenser fan assemblies located in the top of each unit damaged?
Inspect the lower front door and side panels of each unit. Are all door panels intact
Yes No
and air/water tight?
Inspect the blower wheel/housing by looking into the supply opening of each unit. Is
Yes No
the blower wheel centered and able to spin inside the blower housing?
Yes No Inspect all accessories including supply and return louvers. Are they free of damage?
Model and Serial Numbers of HVAC units
Unit Model Number
#1
#2
#3
#4
Model and Serial Number of Controller
Model Number
HVAC Unit Installation – Verify the following:
Verify rain flashing is installed at the top of each unit. Has caulk or sealant been
Yes No
applied per installation instructions to avoid water intrusion into each unit?
Verify all high voltage wire routing requirements are met. Are all conduit connections
Yes No
tightened and sealed for weatherization?
Verify all communication wire routing requirements are met. Are all conduit
Yes No
connections tightened and sealed for weatherization?
Are all HVAC Unit outdoor service and airflow clearances on the sides, front, bottom,
Yes No
and top met?
A 24" minimum distance is needed between the supply and return openings and
Yes No
equipment in the room. Are all HVAC Unit indoor supply and return clearances met?
Controller and Unit Communication Wiring – Verify the following:
7960-788
Revised: 2-13-17
Serial Number
Serial Number
Commissioning Report Page 1 of 3