General Information; Air Conditioning System; Wall-Mount Air Conditioner Units; Controller - Bard FUSION-TEC WR Series Literature Assembly

GENERAL INFORMATION

Air Conditioning System

This Bard air conditioning system is composed of
FUSION-TEC WR Series wall-mounted air conditioners
matched with an LC6000 lead/lag controller. The wall
mounts are specifically engineered for telecom/motor
control center rooms.
NOTE: The LC6000 lead/lag controller and FUSION-
TEC WR Series wall-mount units are designed
specifically to work together. The controller
cannot run other Bard models or other brands of
systems, nor can other controllers run the WR
Series wall-mount units. They are a complete
system, and must be used together.
LC6000-200 Series Controller and Accessories Included with Controller
(1) LC6000 Programmable Logic

Controller

Outside Air
Temperature/Humidity Sensor
Bard P/N 8301-090
One remote temperature/humidity sensor is included with the LC6000 controller. If the site in which the LC6000
1
controller will be used has more than one zone (maximum three zones per LC6000), additional remote temperature/
humidity sensors (one sensor per zone) will need to be purchased and installed in the additional zones. One
additional temperature-only sensor (Bard P/N 8301-058) may also be used in Zone 1 but will also need to be
purchased separately. Additional temperature/humidity sensors require field-supplied 5-wire 18 gauge shielded
cable. Temperature-only sensors require field-supplied 2-wire 18 gauge shielded cable.
Manual 2100-704C
Page 4 of 47

Wall-Mount Air Conditioner Units

The Fusion-TEC WR Series wall-mount units operate on
VAC power. The units will supply 100% of rated cooling
airflow in free cooling mode with ability to exhaust
the same amount through the unit itself without any
additional relief openings in the shelter.
Each of these units are fully charged with refrigerant
and may have optional auxiliary heat.
Controller
LC6000 controller and accessories are shown below.
+
Optional Sensors:
Remote
Temperature/Humidity Sensor
Bard P/N 8403-079
(1) TEC-EYE Hand-Held Diagnostic Tool
TM
Bard P/N 8301-059
(1) Remote Temperature/Humidity Sensor
Bard P/N 8403-079
(1) 35' 5-Wire 18 Gauge Shielded Cable
(2) Communication EMI Filters
Bard P/N 8301-055
Remote
Temperature Only Sensor
1
Bard P/N 8301-058
1