Use; Switching On And Off; Adjusting The Rotational Speed; Guiding The Sabre Blade Safely - Parkside IAN 351750 2007 Translation Of The Original Instructions

Use

Switching on and off
Switching on
♦ First press the safety lock-out
ON/OFF switch
safety lock-out .
Switching off
♦ Release the ON/OFF switch

Adjusting the rotational speed

Press the ON/OFF switch
speed. Increasing the pressure increases the speed.
NOTE
► The integrated motor brake ensures rapid
stoppage.

Guiding the sabre blade safely

To adapt to the workpiece and for safe placement,
the footplate can be swivelled. It must always be
in contact with the workpiece when the appliance
is running.

Practical advice on sawing

♦ Check the material to be worked to make sure
that all foreign objects have been removed,
e.g. nails, screws, etc.
♦ Ensure that the ventilation slits
covered.
♦ Switch the appliance on before moving it
towards the material to be worked.
♦ Switch the appliance off immediately if the saw
blade jams.
Open up the sawn gap using a suitable tool
and pull out the sabre saw.
■ Use the appropriate saw blade
rate for the material to be worked.
■ Saw blades optimised for your sabre saw are
available from retail stores in different lengths
for various purposes.
■ Saw the material at a constant speed.
PSSA 20-Li A1
and then the
. Afterwards, release the
.
lightly for a low
are not
and stroke
Sawing flush to edges
Using flexible saw blades with a suitable
corresponding length, you can saw off protruding
workpieces such as pipes flush to the wall.
Proceed as follows:
1. Place the saw blade
2. Bend it by applying lateral pressure to the sabre
saw so that the footplate
the wall.
3. Switch the appliance on as described and
saw off the work piece by applying constant
pressure.
Plunge sawing:
CAUTION! RISK OF KICKBACK!
■ Plunge cuts may only be made in soft
materials (wood or similar).
Proceed as follows:
1. Place the sabre saw with the lower edge of the
footplate onto the workpiece. Switch the
appliance on.
2. Tilt the sabre saw forwards and plunge the saw
blade into the workpiece.
3. Position the sabre saw vertically and continue
sawing along the cutting line.
directly against the wall.
makes contact with
GB │ IE │
9 ■