Getting Started; Switching The Appliance On/Off; Setting The Rotational Speed; Working Procedures - Parkside PMBA 20-Li B2 Translation Of The Original Instructions

Slide the saw blade 6 into the guide rollers 7
♦
with the saw teeth pointing upwards. Make sure
that the guide rollers 7 firmly grip the saw
blade 6.
NOTE
► Make sure that the direction arrow on the
saw blade 6 (if any) is the same as the one
on the rubber wheels u.
Place the saw blade 6 around the two rubber
♦
wheels.
the saw blade clamping lever 8
♦ Retighten
by turning it anticlockwise
Replace the protective cap t.
♦
WARNING! RISK OF INJURY!
► Do not operate the appliance without the
protective cap t fitted!
♦ Perform a test run by briefly switching the appli-
ance on and off a few times to determine
whether the saw blade is correctly seated.
WARNING! RISK OF INJURY!
► Keep your body away from the sawing
area during the test run!

Getting started

Switching the appliance on/off
Switching on:
♦ Press the safety lock-out 2 and keep it pressed
and then press the ON/OFF switch 3.
After starting, the safety lock-out 2 can be
♦
released again.
The LED work light a lights up when the ON/
♦
OFF switch 3 is pressed lightly or fully. This
provides illumination of the work area in poor
lighting conditions.
Switching off:
♦ Release the ON/OFF switch 3.
PMBA 20-Li B2
again.

Setting the rotational speed

Adjust the speed adjustment wheel 1 to a
♦
position between 1 and 6.

Working procedures

♦ Secure the workpiece against slipping, e.g.
with a vice.
♦ Use the weight of the saw when sawing. Do not
exert any additional pressure.
♦ Wait until the saw has reached its full speed
before carefully bringing it into contact with the
workpiece.
If the saw blade 6 blocks, switch off the appli-
♦
ance immediately.
Do not twist the saw blade 6 while making
♦
the cut.
WARNING! RISK OF INJURY!
► Do not remove the workpiece until the saw
has come to a standstill.

Maintenance and cleaning

WARNING! RISK OF INJURY! Always
switch the appliance off and remove
the battery before carrying out any
work on the appliance.
■ Store the appliance and the saw blades in a
dry and dust-free location.
■ The appliance must be kept clean and free
of oil or grease.
■ Use a dry cloth to clean the housing.
■ Never obstruct the ventilation openings.
■ Use a brush to remove any sawdust that has
stuck to the appliance.
NOTE
► Replacement parts not listed (such as switches
or saw blades) can be ordered via our
Service Hotline.
GB │ IE │
9 ■