1.3.4
COM Specifications (GTN 750 Only)
1.3.4.1 COM Transmitter Specifications
Classes
Microphone Input
Modulation Capability
Modulation
Frequency Range
Frequency Tolerance
Output Power
Duty Cycle
Carrier Noise Level
Stuck Mic Time-Out
Demodulated Audio Distortion
Sidetone
1.3.4.2
COM Receiver Specifications
Classes
Frequency Range
Headset Audio Output
Speaker Audio Output
Audio Response
Audio Distortion
AGC Characteristics
Sensitivity
Squelch
Selectivity
Page 1-4
Rev. A
3,4,5,6
Two inputs, standard carbon or dynamic mic with integrated
preamp providing minimum 70 mVRMS into 1000 load
85% with 100 to 1000 mVRMS microphone input at 1000 Hz
AM Double sided, Emission Designator 6K00A3E
118.000 to 136.975 MHz, 25 kHz and 8.33 kHz channel spacing
+/-2ppm from -40°C to +70°C
10 Watt Mode: 10 watts minimum
16 Watt Mode: 16 watts minimum
10W: 100%
16W: Recommended 25% (15 seconds on/45 seconds off,
5 seconds on/15 seconds off, etc.)
At least 35 dB (SNR).
35 seconds time-out, reverts to receive
Less than 5% distortion when the transmitter is at 85%
modulation at 350 to 2500 Hz
1.4 Vrms into a 500 load
D and E
118.000 to 136.975 MHz, 25 kHz and 8.33 kHz channel spacing
110 mW minimum into a 500 load
12 watts minimum into a 4 load
Less than 6 dB of variation between 350 and 2500 Hz.
Less than 5% at rated output power
Less than 3 dB of variation in the audio output from -93 to -13
dBm (power absorbed by a 50Ω load)
SINAD on all channels is greater than 6 dB when the RF level is
2 uV (hard) or -107 dBm (power absorbed by a 50Ω load)
modulated 30% at 1000 Hz at rated audio output power
Automatic squelch with manual override
6 dB BW is greater than + 7 kHz for 25 kHz channeling.
60 dB BW is less than ±22 kHz for 25 kHz channeling.
6 dB BW is greater than ±3.5 kHz for 8.33 kHz channeling.
60 dB BW is less than ±7.37 kHz for 8.33 kHz channeling.
GTN 725/750 TSO Installation Manual
190-01007-02