IBM PS/2 90 XP 486 Hardware Maintenance Reference page 33

Hide thumbs Also See for PS/2 90 XP 486:

Table of Contents

2.6.2 Example:

Changing the Startup Sequence

Assume the following drives are installed in the system:

Diskette Drives

3.5-inch diskette drive (primary diskette drive)

3.5-inch diskette drive (second diskette drive)

5.25-inch diskette drive (third diskette drive)

Hard Disk Drives

400MB hard disk drive (primary hard disk drive) divided into two

200MB partitions.

If you want to start the system from a 3.5-inch diskette, a 5.25-inch

diskette, or the hard disk drive, you can define the startup sequence as

follows:

Startup Number

1..............[2.88MB 3.5-inch Diskette Drive 0]

2..............[1.2MB 5.25-inch Diskette Drive 2]

3..............[SCSI hard disk slot 1 (ID, LUN)...:6,0]

4..............[Not selected]

In this example, the system looks for a startable diskette in the primary

3.5-inch diskette drive, and then looks for a startable diskette in the

5.25-inch diskette drive.

drive, the system loads the operating system from the System Partition on

the hard disk drive.

IBM PS/2 Model 90 XP 486 and 95 XP 486 HMR

Example: Changing the Startup Sequence

Device

If there is not a startable diskette in either

2.6.2 - 1

Table of Contents

Ps/2 95 xp 486