Life Fitness CLUB Series Assembly Instructions Manual page 10

1A
FIGURE 7
STEP 7
:
• SECURELY assemble the BACK PIVOT (5) to the REAR FRAME (6) using four previously inserted 3/8 X 3" BUTTON HEAD
CAP SCREWS (17), four RH WASHERS (23), four 3/8" SAE WASHERS (22), four 3/8" LOW HEIGHT LOCK NUTS (21) and
four RH CAPS (28) as shown in FIGURE 7.
• IMPORTANT! When BACK PIVOT (5) is centered and level in the PILLOW BLOCKS (25), tighten the PILLOW BLOCK set
screws.
25
TIGHTEN!
SET SCREWS
10
5
23
17 3/8 X 3" BUTTON HEAD
6
22
28
21