Crotch Buckle Position; Harness Length Adjustment; Locking Clip Use; Upper Seat Back Removal And Installation - Baby Trend CV88C Owner's Manual

5.0 Installation and Use
5.12 Crotch Buckle Position
1. Press the crotch buckle release button
down with fingers and move position.
2. Crotch buckle placement:
Rear facing - rear most position
Forward facing - forward most position

5.13 Harness Length Adjustment

1. Unhook the harness straps from the metal
plate and move to the desired adjustment.
2. Feed one Harness Strap Connector plate
through each Harness Strap End
other Harness Strap Connector Plate and feed
through each Harness Strap End
Straps are securely connected to both connector plates
3. Ensure the harness strap ends are fully
hooked on the metal plate. Both sides must
be threaded in the same position.
45
. Rotate
. Ensure that the
.
Copyright © 2016, Baby Trend, Inc.
5.0 Installation and Use

5.14 Locking Clip Use

1. If your vehicle lap/shoulder belt requires the
use of a Locking Clip to prevent the belt from
loosening after installation, thread the locking clip on the belt as
close to the latch plate as possible – within 1 inch (2.54 cm).
5.15 Upper Seat Back Removal and Installation
WARNING
The upper seat back must be installed:
When the child weighs more than 22 lbs (9.98 kg)
or
Top of head has reached max height
red line on seat back.
or
The restraint is forward facing.
1. Removal: Remove the upper seat back by
lifting the release tab and pulling up on the
upper seat back.
NOTE: DO NOT store the upper seat back in
the passenger compartment. Store the upper
seat back in a secure location like your trunk
or garage.
2. Installation: Align the upper seat back rods
and push rods into the openings until you
hear the seat back lock into place. Pull up on
the upper seat back to ensure the removable
upper seat back is locked in position.
Copyright © 2016, Baby Trend, Inc.
1 inch (2.54 cm)
Click
46