Adjusting The Volume - Canon i-SENSYS MF729Cx Important Safety Instructions And Installation Manual

Adjusting the Volume

The machine produces sounds in a variety of situations, such as when fax sending is complete or when a paper jam or error occurs. You
can set the volume of each of these sounds individually.
Adjusting <Fax Volume>
1
Press the ( ) key.
2
To change <Fax Volume>, tap
You can also adjust the volume by flicking the slider.
Tap and move the cursor all the way to the left to mute the sound.
Adjusting <Other Volume>
1
Press ( ) key.
For MF729Cx / MF728Cdw / MF628Cw, tap <Other Volume>.
2
Select a setting.
Setting
*
<Ring Tone> Sound produced when an incoming fax is received
<TX Done
Sound produced when fax sending is complete
Tone> *
<RX Done
Sound produced when fax receiving is complete
*
Tone>
<Scanning Done
Sound produced when fax document scanning is complete
*
Tone>
Confirmation sound each time a key on the operation panel or button
<Entry Tone>
on the display is pressed
<Invalid Entry Sound produced when an invalid key operation is performed, such as
Tone> when you enter a number outside the valid setting range
<Restock
Sound produced when a toner cartridge is almost empty
Supplies Tone>
<Warning Tone> Sound produced when a paper jam or other error occurs
<Job Done Sound produced when an operation such as copying or scanning is
Tone> complete
<Energy Saver
Sound produced when the machine enters or exits sleep mode
Alert>
<Original in
/ , and tap <Apply>.
Description
0SCJ-01A
Procedure
Go to step 3.
Select <On> (produce a tone)
or <Off> (not produce a tone).