Fan Mode Reset; Fan Delay; Programmable Mode (Fcp-Pa Only); Enabling The Programmable Mode - Johnson Controls FCP-NA-701-L User Manual

1. Press Mode to set the thermostat to OFF mode.
Press and hold Mode and Fan for 5 seconds to access the advanced settings menu.
2.
3. Press Up to navigate to IS, then press Mode to enter the menu.
Press Mode to navigate to 53.
4.
5. Use the Up and Down buttons to set smart auto fan to On or Off and press Mode to confirm
the change.

Fan mode reset

The fan mode reset function resets the fan mode to Auto after the fan mode reset time elapsed.
You can set the fan mode reset time to 2 hours, 4 hours, and 24 hours. By default, the fan mode
reset time is set to Off. To set the fan mode reset time, complete the following steps:
1. Press Mode to set the thermostat to OFF mode.
2. Press and hold Mode and Fan for 5 seconds to access the advanced settings menu.
3. Press Up to navigate to IS, then press Mode to enter the menu.
Press Mode to navigate to 54.
4.
5. Use the Up and Down buttons to set the fan mode reset time and press Mode to confirm the
change.

Fan delay

Fan delay is a time delay for the fan terminal to turn off after the heating or cooling terminal turned
off. The fan delay is available when the fan mode is Auto. You can set a delay between 0 seconds
and 10 seconds. To set the fan delay, complete the following steps:
Press Mode to set the thermostat to OFF mode.
1.
2. Press and hold Mode and Fan for 5 seconds to access the advanced settings menu.
Press Up to navigate to IS, then press Mode to enter the menu.
3.
4. Press Mode to navigate to 56.
Use the Up and Down buttons to set the fan delay time and press Mode to confirm the
5.
change.

Programmable mode (FCP-PA only)

The programmable mode is available on the FCP-PA model only. With the programmable mode you
can set a heat and cool schedule for up to seven consecutive days and each day can consist of up
to six periods. You can change the start times of each period by increments of 15 minutes. You can
also set the time and date in the programmabe mode.

Enabling the programmable mode

To enable the programmable mode, complete the following steps:
Press Mode to set the thermostat to OFF mode.
1.
2. Press and hold Mode and Fan for 5 seconds to access the advanced settings menu.
Press Up to navigate to UP, then press Mode to enter the menu.
3.
4. Press Mode to navigate to 10.
5. Use the Up and Down buttons to set the programmable mode to ON and press Mode to
confirm the change.
18 FCP Non-Programmable and Programmable Fan Coil or PTAC Thermostat Largo User Guide