Dc Fan (Fan Holder Assembly (B)) - Sony XVS-8000-C Service Manual

Procedure
1. Disconnect the harness from the connector (CN002) on the CN-3824 board.
2. Disconnect the harness from the connector (CN004) on the CN-3824 board.
3. Open the clamper, then release the two harnesses.
4. Remove the two screws [a], then remove the DC fan (120 square) (thick type).
5. Remove the two screws [b].
6. Pull out the harness from the hole, then remove the DC fan (120 square) (thin type).
DC fan(120 square) (Thick type)
Label
CN-3824 board
CN002
Note
When attaching the DC fan, pay attention to the position of label and harness.
7. Install the removed parts by reversing the steps of removal.
4-4-3.

DC Fan (Fan Holder assembly (B))

Preparation
1. Remove the fan holder assembly. (Refer to
Procedure
1. Disconnect the harness from the connector (CN002) on the CN-3824 board.
XVS-8000-C/XVS-8000
[a]
PSW3 x 30
CN004
Clamper
"4-4-1. Fan Holder
[b]
PSW3 x 30
DC fan(120 square) (Thin type)
[b]
PSW3 x 30
Label
Harnesses
Hole of the chassis
Assembly")
4-5