Items Required For Installation - Kenwood TK-5210 Modification Information

2. Select Edit menu > "Extended Function".
The Extended Function window appears on the
display.
3. Select "ANI Board" from the Optional Board
dropdown list.
Refer to the ANI Board's instruction manual for
instructions on how to configure the ANI Board.
4. Write configuration data to the transceiver.
Refer to the Field Programming Reference for
instructions on how to write the configuration data to
the transceiver.
2.3 Man-down Tilt Switch for
Emergency Mode
The Man-down Tilt Switch can be installed in the
transceiver. This section describes how to install the
Man-down Tilt Switch in the TK-5120.

Items Required for Installation

• Transceiver
• Man-down Tilt Switch
• Cushion
• Attached heat shrink tube
• 2 cables (blue and black)
*1
The Cimarron CAE-3 is used in this example.
Remove the battery pack to install the Man-down Tilt
Switch.
MOD (K)/Ver. 1.04
*1
2 CONNECTING THIRD PARTY OPTIONAL DEVICES
2.3.1 Configuring and Modifying the
Man-down Tilt Switch
1. Prepare the Man-down Tilt Switch.
2. Cut cables (blue and black) to approximately
2" (50 mm).
1/8"
(3 mm)
3. Solder the cables (black and blue) to the position
shown in the figure.
3. Install the heat shrink tube (black, approx. 10 mm) on
the blue cable side in order to hide the soldered part.
Black
Confidential
2" (50 mm)
Blue
Heat shrink tube
Contents
1/8"
(3 mm)
11