Options Installation - Kenwood TS-50S Instruction Manual

10 OPTIONS INSTALLATION
Caution: UNPLUG THE DC POWER CABLE BEFORE
BEGINNING INSTALLATION.
MENU SET-UP CHANGE
To use the new filter, change the Menu Set-up with
FILTER this procedure:
1 Remove the transceiver top cover (7 screws). 1 Connect the DC power cable.
2 Switch on the power.
3 Hold the F.LOCK button for more than two
seconds to enter the Menu Set-up mode.
4 Press the A/B button to select Menu A.
5 Select Menu No. 03 with the tuning control.
6 Select the SSB or CW made.
2 Remove the speaker and speaker bracket. 7 Select 0.5 kHz with the UP or DOWN button.
3 Remove the screw that secures the smail board to The -Nindicator. appears in the modulation mode
: area.
the main board.
4 Remove the small board from the main board.
S oa PER Ore LOCK button toexit Ment
Note the orientation.
5 Solder the filter onto the board . Use a low power
iron (25W) and rosin core solder. Do not overheat
the PC beard and lift foil ages and do not use .
er sie 4, r Pe sis =
6 Reinstall the small board with the screw. Orient
Fs rr or! ao
Note: Be careful not to pinch your fingers nor the wires,
55