Table of Contents
Advertisement
Step 4: Connect Power Cables
Connect Power to an AC-Powered Controller
Copyright © 2013, Juniper Networks, Inc.
Figure 7: Console Port Location
USB
Front
maintenance
panel
port
C5000
CONSOLE ETH0
ETH1
ETH2
ETH3
Console
Network
port
ports
Depending on your configuration, your controller uses either AC or DC power supplies.
Perform the appropriate procedures for each power supply in your controller.
Connect Power to an AC-Powered Controller on page 7
Connect Power to a DC-Powered Controller on page 8
NOTE:
C3000 and C5000 Controllers now ship with a retainer clip for the
power cord. The retainer clip prevents accidental disconnection of the power
cord by securing the cord to the chassis. Steps
equipped with retainer clips.
To connect AC power to a C3000 or C5000 Controller:
Squeeze the two sides of the power cord retainer clip and insert the L-shaped ends
1.
of the wire clip into the holes in the bracket on each side of the AC appliance inlet.
Figure 8: Connecting Power on an AC-Powered C3000 or C5000
Controller
Insert the coupler end of the power cord into the AC appliance inlet.
2.
If your controller contains two power supplies, plug each power cord into a separate
power circuit to ensure that the device continues to receive power if one of the power
circuits fails.
Step 4: Connect Power Cables
Hard disks
IOC expansion slots
1
and
3
apply only to appliances
7
Advertisement
Table of Contents
