Table of Contents
Advertisement
C Series C3000 and C5000 Controller Quick Start
14
WARNING:
Be sure that circuit breakers for the power source are in the OFF
position before attaching power cables.
WARNING:
Before servicing the system, turn off the power.
WARNING:
Remove jewelry (including rings, necklaces, and watches) before
working on equipment that is connected to power lines. Metal objects heat
up when connected to power and ground and can cause serious burns or
become welded to the terminals.
CAUTION:
Evaluate the overall loading of the branch circuit before you install
any equipment into a rack.
WARNING:
There is a danger of explosion if the battery is incorrectly replaced.
Return the device to the manufacturer for battery replacement. Moreover,
never open the chassis under any circumstances. Doing so will also void the
warranty.
WARNING:
La batterie présente un risque d'explosion si elle n'est pas
remplacée comme il se doit. Retournez l'appareil au fabricant pour faire
remplacer la batterie. Le châssis ne doit par ailleurs en aucun cas être ouvert.
Cela annulerait la garantie.
WARNING:
Before working on a device that has an On/Off switch, turn the
power off and disconnect the power cord to all power supplies.
For DC power supplies, locate the circuit breaker on the panel board that
services the DC circuit, switch the circuit breaker to the off position, and tape
the switch handle of the circuit breaker in the off position.
WARNING:
Avant de commencer à travailler sur un appareil muni d'un
interrupteur On. Off (Marche/Arrêt), Coupez l'alimentation et débranchez le
cordon d'alimentation de toute source d'alimentation.
Dans le cas d'une alimentation à courant continu, repérez le disjoncteur sur
le tableau de contrôle qui alimente le circuit c.c., placez-le en position d'off
Copyright © 2013, Juniper Networks, Inc.
Advertisement
Table of Contents
