Peripheral Devices And Options; Bypass Options - YASKAWA HV600 Installation & Startup

6.6 Peripheral Devices and Options

6.6

Peripheral Devices and Options

◆
Bypass Communication Options
There are many available peripheral devices and options for the bypass.
Refer to the HV600 catalog (CA.HV600.01) for information about available options, including:
• Main circuit options
• Frequency settings and monitor options
• Keypad options
• Attachment options
• Engineering tools
Contact Yaskawa or your nearest sales representative to make an order.
Refer to the instruction manual for each option for wiring information.
◆
Tools Required for Option Installation
• A Phillips screwdriver (M3 metric or #1, #2 U.S. standard) to install the option and remove the bypass front cover.
Screw sizes vary by capacity. Select a screwdriver appropriate for the capacity.
Note:
Use a short-shaft, magnetic screwdriver when installing the option card into the narrow enclosure models H6BPD002 to D074 and B001 to
B077.
• A straight-edge screwdriver (blade depth: 0.4 mm, width: 2.5 mm) to wire the option terminal block when installing
the SI-W3 LonWorks option.
Note:
This manual does not list the tools required to prepare the option cables for wiring.
◆

Bypass Options

These configurations are available for the bypass:
■
Option B
Three-contactor bypass: Isolates the drive circuit by adding a separate drive input contactor.
■
Option D
Ethernet/IP option.
■
Option G
Drive Input Disconnect Switch: Provides a disconnect means for the input side of the Drive, for Drive isolation
capability during bypass operation. This disconnect is located inside the enclosure with an integral operating handle.
■
Option L
Serial Communication, Echelon LonWorks: An isolated circuit board provides LonTalk protocol for network
communication to a BAS. This option plugs into the CN5 connection on the bypass control circuit board.
■
Option M
Lockable Circuit Breaker SCCR panel rating of 100 kA (no external customer fuses or internal fuses are necessary)
■
Option W
Custom Nameplate: Provides a custom nameplate for placement on the front of the bypass.
164 YASKAWA TOEPYAIH6B01A HV600 AC Drive Narrow Bypass Installation & Startup