Setting Port Vid; Figure 21 Initial Setup Network Example: Port Vid - ZyXEL Communications ES-3148 Series User Manual

Chapter 5 Initial Setup Example
2 In the Static VLAN screen, select
ACTIVE, enter a descriptive
name in the Name field, and enter
2 in the VLAN Group ID field for
the VLAN2 network.
The VLAN Group ID field in this screen and the VID field in the IP Setup
screen refer to the same VLAN ID.
3 Since the VLAN2 network is connected to port 1 on the Switch, select Fixed to
configure port 1 to be a permanent member of the VLAN only.
4 To ensure that VLAN-unaware devices (such as computers and hubs) can receive frames
properly, clear the TX Tagging check box to set the Switch to remove VLAN tags
before sending.
5 Click Add to save the settings to the run-time memory. Settings in the run-time memory
are lost when the Switch's power is turned off.

5.1.2 Setting Port VID

Use PVID to add a tag to incoming untagged frames received on that port so that the frames
are forwarded to the VLAN group that the tag defines. In the example network, configure 2 as
the port VID on port 1 so that any untagged frames received on that port get sent to VLAN 2.

Figure 21 Initial Setup Network Example: Port VID

64
ES-3148 User's Guide