Mounting The Switch On A Rack; Figure 8 Mounting The Switch On A Rack - ZyXEL Communications ES-3148 Series User Manual
Es-3148 series intelligent layer 2+ switch
Hide thumbs
Also See for ES-3148 Series:
- User manual (330 pages) ,
- Release note (4 pages) ,
- Support notes (144 pages)
Table of Contents
Advertisement
2 Using a #2 Phillips screwdriver, install the M3 flat head screws through the mounting
bracket holes into the Switch.
3 Repeat steps
Switch.
4 You may now mount the Switch on a rack. Proceed to the next section.
2.2.3 Mounting the Switch on a Rack
1 Position a mounting bracket (that is already attached to the switch) on one side of the
rack, lining up the two screw holes on the bracket with the screw holes on the side of the
rack.
Figure 8 Mounting the Switch on a Rack
2 Using a #2 Phillips screwdriver, install the M5 flat head screws through the mounting
bracket holes into the rack.
3 Repeat steps
ES-3148 User's Guide
1
and
2
to install the second mounting bracket on the other side of the
1
and
2
to attach the second mounting bracket on the other side of the rack.
Chapter 2 Hardware Installation and Connection
41
- Quick Links:
- Hardware Overview
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
