ZyXEL Communications ES-3148 Series User Manual page 81

Table 12 Basic Setting > IP Setup (continued)
LABEL
Static IP
Address
IP Address
IP Subnet
Mask
Default
Gateway
VID
Out-of-band Management IP Address
IP Address
IP Subnet
Mask
Default
Gateway
Apply
Cancel
In-band IP
Addresses
IP Address
IP Subnet
Mask
VID
Default
Gateway
Manageable
Add
Cancel
Index
IP Address
IP Subnet
Mask
VID
Default
Gateway
ES-3148 User's Guide
DESCRIPTION
Select this option if you don't have a DHCP server or if you wish to assign static IP
address information to the Switch. You need to fill in the following fields when you select
this option.
Enter the IP address of your Switch in dotted decimal notation for example 192.168.1.1.
Enter the IP subnet mask of your Switch in dotted decimal notation for example
255.255.255.0.
Enter the IP address of the default outgoing gateway in dotted decimal notation, for
example 192.168.1.254.
Enter the VLAN identification number associated with the Switch IP address. VID is the
VLAN ID of the CPU and is used for management only. The default is "1". All ports, by
default, are fixed members of this "management VLAN" in order to manage the device
from any port. If a port is not a member of this VLAN, then users on that port cannot
access the device. To access the Switch make sure the port that you are connected to
is a member of Management VLAN.
Enter the IP address of your Switch in dotted decimal notation for example 192.168.0.1.
If you change this IP address, make sure the computer connected to this management
port is in the same subnet before accessing the Switch.
Enter the IP subnet mask of your Switch in dotted decimal notation for example
255.255.255.0.
Enter the IP address of the default outgoing gateway in dotted decimal notation, for
example 192.168.0.254.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to reset the fields.
You can create up to 64 IP addresses which are used to access and manage the Switch
from the ports belonging to the pre-defined VLAN(s). You must configure a VLAN first.
Enter the IP address for managing the Switch by the members of the VLAN specified in
the VID field below.
Enter the IP subnet mask in dotted decimal notation.
Type the VLAN group identification number.
Enter the IP address of the default outgoing gateway in dotted decimal notation.
Select this option to allow the Switch to be managed using this specified IP address.
Click Add to save the new rule to the Switch's run-time memory. It then displays in the
summary table at the bottom of the screen.
Click Cancel to reset the fields.
This field displays the index number of an entry. Click an index number to edit the rule.
This field displays the IP address.
This field displays the subnet mask.
This field displays the VLAN identification number of the network.
This field displays the IP address of the default outgoing gateway.
Chapter 7 Basic Setting
81