Uploading A Configuration File Via Console Port; Figure 2-3 Example Xmodem Upload - ZyXEL Communications ZyAIR Wireless Gateway Series User Manual

2.3.2 Uploading a Configuration File via Console Port

This method is only applicable to ZyAIR models with a console port, such as the ZyAIR B-2000.
Step 1. Download the default configuration file from the ZyAIR FTP site, unzip it and save it in a folder.
Step 2.
Turn off the ZyAIR, begin a terminal emulation software session and turn on the ZyAIR again.
When you see the message "Press any key to enter Debug Mode within 3 seconds", press any key
to enter debug mode.
Step 3. Enter "y" at the prompt below to go into debug mode.
Step 4. Enter "atlc" after "Enter Debug Mode" message.
Step 5. Wait for "Starting XMODEM upload" message before activating Xmodem upload on your
terminal. This is an example Xmodem configuration upload using HyperTerminal.
Step 6. Click Transfer, then Send File to display the following screen.
Step 7. After successful firmware upload, enter "atgo" to restart the ZyAIR.
Introducing the Web Configurator

Figure 2-3 Example Xmodem Upload

ZyAIR Wireless Gateway Series User's Guide
Type the configuration file's
location, or click Browse...
to search for it.
Choose the Xmodem
protocol.
Then click Send.
2-3