Additional Setup Requirements; The Link Info Screen; Figure 50 Access Point Mode: Link Info; Table 18 Access Point Mode: Link Info - ZyXEL Communications ZyXEL AG-220 User Manual

ZyXEL AG-220 User's Guide

5.1.2 Additional Setup Requirements

To bridge your wired and wireless network using the AG-220, the following requirements
must be met:
1 The AG-220 must be installed on a computer connected to the wired network.
2 Either bridge the two interfaces (wireless and wired) on the computer (using the
Configuration screen of the ZyXEL utility in Windows XP) or configure network
sharing (refer to
3 Set the wireless station's IP address to be dynamic if you want the wireless stations to
access the wired network or the Internet through the AG-220. Refer to
page 121

5.2 The Link Info Screen

Select the AP Mode check box and wait for about five seconds to display the screen as shown.

Figure 50 Access Point Mode: Link Info

The following table describes the labels in this screen.

Table 18 Access Point Mode: Link Info

LABEL
Status
SSID
Current Channel
Transmission Rate This field displays the current transmission rate of the AG-220 in megabits per
74
Appendix B on page 89
for how to configure your computer's IP address.
DESCRIPTION
This field displays the name that identifies your AG-220 in the wireless LAN
network.
This field displays the radio channel the AG-220 is currently using.
second (Mbps).
for an example).
Chapter 5 Access Point Mode Configuration
Appendix E on