Advertisement
ERROR CODE E11:
The compressor could be protected against overloads by thermistor
devices.
This type of Alarm is activated by the digital input J6 (7-8) on the main
board and it causes an interruption of the working cycle in progress.
Setting the parameter
digital inputs.
All functions could be restored automatically and a new cycle can re-
start again when the cause of the alarm is ended.
The display on the user interface shows the ERROR codes. This condition
causes the following event:
The red Alarm Service Led is flashing
The buzzer is active
The display shows the ERROR code
High or Low temperature in the compressor due to at flash gas or air
COMPRESSOR OVERLOAD
"CPt"
on the unit is possible enable or disable this
ALARMS CONDITIONS
flow compressor stopped
Or compressor windings faulty
- 74 -
"E11"
Hide quick links:
Advertisement
