Selecting And Playing Patches; Panel Display; Selecting A Patch - Zoom GFX-3 Operation Manual

Selecting and Playing Patches

Immediately after you turn on the GFX-3, it is always in the condition for playing patches stored in memory.

Panel display

When a dot (.) is shown here,
patches can be selected from a user
N
OTE
• While a patch is being modified, the
setting value of the currently selected
parameter is shown on the display. To
return to the group/bank display, press
the [GROUP/EXIT] key.
• While the setting value of a parameter is
shown, take care not to accidentally
switch the patch. Otherwise the setting
contents will be lost.

Selecting a patch

1.
To select a patch, press one of the
foot switches [1] - [3] whose LED is
not lit.
The LED of the foot switch for the patch that is
currently selected is lit.
N
OTE
If you press the foot switch whose LED is lit,
the unit goes into bypass/mute condition
(→ p. 11).
2.
To select a patch in another group
or bank, use the BANK [
and then the foot switches [1] - [3]
to select the group and bank.
10
Group (U/u, A/b)
group or preset group.
The keys for effect modules that are ON in this patch are lit.
Q W
]/[ ] keys
Immediately after you turn on the GFX-3, the
following information is shown on the panel.
Bank number (0 - 9)
When a dot (.) is shown here,
the patch has been modified.
For example, if you repeatedly press the BANK
Q
[ ] key, the group/bank is switched as follows.
User groups
Preset groups
A 0 A 1 A 9
Pressing foot switches [1] and [2] together has
the same effect as pressing the BANK [
and pressing foot switches [2] and [3] together
has the same effect as pressing the BANK [
key.
3.
To limit the patch selection to user
groups or preset groups only,
press the [GROUP/EXIT] key.
Each time you press the key, the available
groups change as follows.
User groups
Both groups
only
Dot is lit
B 0 B 9
W
] key,
Q
]
Preset groups
only
A 1
ZOOM GFX-3