Zoom GFX-3 Operation Manual page 7

N
OTE
If you turn the GFX-3 on while the amplifier is
already powered up, damage to the speaker
may result. Always turn power to the amplifier
on last. When turning off the system, proceed
in the opposite order.
6.
Press the leftmost module key
(ZNR/[TOTAL]) and then the lowest
parameter key.
The respective key flashes, and the Energizer
function for matching the GFX-3 to the playback
system can be used. The display shows the
current setting.
Module key
(ZNR/[TOTAL])
Connect the guitar output
jack to the [INPUT] jack on
the GFX-3.
Guitar
ZOOM GFX-3
Parameter key
Headphones
7.
While playing your instrument, turn
the [VALUE] dial until the sound
quality is as desired.
As you turn the dial, the display indication
changes between oF and 1 - 30. Higher setting
values result in stronger emphasis of the low
range, and lower setting values in stronger
emphasis of the high range. The "oF" setting
means that the Energizer function is turned off.
8.
To turn the system off, proceed in
the opposite order than when
turning it on.
When using only one guitar amp, connect it to the
[OUTPUT/PHONES] jack with a shielded instrument
cable. By using a Y-cable and connecting two guitar
amplifiers to the [OUTPUT/PHONES] jack, you can
achieve reverb and chorus sound with a wide stereo
spread.
Connect the separately available AC
adapter (ZOOM AD-0006) here.
Guitar amps
Loop the cable of the AC
adapter around the hook before
connecting it to the [DC IN]
jack. This will prevent the plug
from being disconnected if the
cable is accidentally pulled.
Getting Ready to Play
AC adapter
7