Zoom GFX-3 Operation Manual page 22

REV/DLY (Reverb/Delay) module
Parameter 3
Adjusts the reverb sound volume level.
TYPE 4: MN-DLY ( M M M M D D D D ) (Mono delay)
This is a monaural delay with a duration of up to 1.5 seconds.
TYPE 5: PP-DLY ( P P P P D D D D ) (Ping-Pong Delay)
When two amplifiers are used, this serves as a ping-pong delay effect with a duration of up to 1.5 seconds. When one amplifier is used, the effect is
a mono delay.
TYPE 6: ECHO ( E E E E C C C C )
This is a monaural echo simulating a tape echo.
TYPE 7: PP-ECHO ( P P P P E E E E ) (Ping Pong Echo)
When two amps are used, the delay sound moves back and forth between them. When one amp is used, the effect is the same as for monaural echo.
* Parameters for TYPE 4 - 7 are the same.
Parameter 1
1 – 99, 1.0 – 1.5, t1 – t9
Adjusts the delay time in 10-ms steps in the range of 10 - 990 ms (1 -
99), and in 100-ms steps above 1 s (1.0 - 1.5). By selecting t1 - t9, you
can specify a note referenced to BPM as set with parameter 4. (See
Table 3)
Parameter 3
Adjusts delay sound level.
[Table 3]
Value t1
dotted
Corresponding
half note
note
quarter note
TYPE 8: REVERSE ( R R R R E E E E )
Produces a sound like a tape played in reverse.
Parameter 1
5 – 99, 1.0 – 1.5, t1 – t9
Adjusts the delay time.
Parameter 3
Adjusts the delay sound level.
TYPE 9: DLYHAL ( D D D D H H H H ) (Delay + Hall Reverb)
This is a combined delay and hall reverb effect.
TYPE 10: DLY+ROOM ( D D D D R R R R ) (Delay + Room Reverb)
This is a combined delay and room reverb effect.
TYPE 11: DLY + SPRING ( D D D D S S S S ) (Delay + Spring Reverb)
This is a combined delay and spring reverb effect.
* Parameters for TYPE 9 - 11 are the same.
Parameter 1
Adjusts the delay time in 10-ms steps in the range of 10 - 500 ms.
Parameter 3
Adjusts the delay sound level.
22
MIX
0 – 30
TIME
MIX
0 – 30
t2 t3 t4
dotted
quarter note
eighth note
TIME
MIX
0 – 50
DLYTIM
1 – 50
DLYMIX
0 – 15
Parameter 2
0 – 10
Adjusts number of repeat cycles (feedback) for delay sound.
Parameter 4
40 – 199
Adjusts the delay time in BPM (beats per minute). This setting is valid
only when parameter 1 is t1 - t9. Settings of 100 and above are shown
with a dot (.) between the two figures.
t5 t6
half triplet dotted
eighth note
note sixteenth note
Parameter 2
0 – 10
Adjusts number of repeat cycles (feedback) for delay sound.
Parameter 4
40 – 199
Adjusts the delay time in BPM (beats per minute). This setting is valid
only when parameter 1 is t1 - t9. Settings of 100 and above are shown
with a dot (.) between the two figures.
Parameter 2
0 – 10
Adjusts the delay feedback amount.
Parameter 4
0 – 15
Adjusts the reverb volume level.
FB
DLYBPM
t7 t8 t9
quarter sixteenth
triplet note note
FB
DLYBPM
DLYFB
REVMIX
ZOOM GFX-3