Selecting A Patch For Playing - Zoom G1N Operation Manual

Selecting a Patch for Playing (Play Mode)
This section explains basic functions of the play mode.
1
Turn power on
The volume control on the connected amplifier
should be turned down.
When using the unit on batteries
Plug a shielded cable into the [INPUT] jack.
When using the unit with an AC adapter
Plug the cable from the adapter into the [DC IN]
jack.
Turn the guitar amplifier on and adjust the volume to
a suitable position.
2
Set the G1N/G1XN to play mode
Set the Module selector to "PLAY".
The bank and patch number are shown on the display.
Immediately after turning the G1N/G1XN on, the unit
HINT
will be in play mode, regardless of the position of the
Module selector.
8
Bank Patch
name number
ZOOM G1N/G1XN
3
Select a patch
Use the foot switches.
Press the [ ] foot switch to call up the next higher
Q
patch.
Press the [ ] foot switch to call up the next lower
W
patch.
Repeatedly pressing one foot switch cycles through
patches in the order A0 – A9 ... d0 – d9, 00 – 09 ...
30 – 39, A0.
4
Directly switch a bank
Press the [BANK UP·TAP] key.
Repeatedly pressing the key cycles through banks in
the order A ... d, 0 ... 3, A.
With the G1N, using the foot switch (FS01) to switch
HINT
banks is also possible ( g p. 18).
5
Adjust the master level
Operate the [VALUE] knob.
The master level setting appears on the display.
The master level setting applies to all patches. The
setting range is 0 – 98, 1.0. It will be reset to 80 when
power is turned off and then on again.
When using headphones, this knob adjusts the listening
HINT
volume.
ZOOM G1N/G1XN
Selecting a Patch for Playing (Play Mode)
A0 A1
A0 39
A0 B0
MN
80
MN
9