General Safety Instructions - Siemens 1FS6 Series Instructions Manual

1

General safety instructions

The servomotors correspond to the harmonized standards of the
EN 60034-1, EN 60034-9 and EN 60204-1.
The three-phase servomotors 1FS6 confirm:
73/23/EWG
98/37/EG
89/336/EWG
94/9/EG
Ensure that your end product conforms to all currently valid legal requirements.
Follow the compulsory national, local and installation-specific regulations.
Three –phase servomotors are exclusively intended for fitting in another machine or
machines.
These motors must be brought into use it has been established that the end product
conforms to the currently valid directives.
All safety instructions must be observed during the transport, storage, assembly,
disassembly and operation of the servomotors!
The motors rotors contain permanent magnets with high magnetic flux densities which exert
strong attractive forces on ferromagnetic bodies. People fitted with a heart pacemaker are
at risk in the vicinity of a disassembled rotor. Data stored on electronic data media may be
destroyed.
Failure to observe the instructions can lead to serious personal injuries or property
damage.
Thermal hazards
The surface temperatures of the motors can reach up to 140 °C (284 °F).
Do not touch hot surfaces!
Temperature-sensitive components (electric lines, electronic components) must not touch
hot surfaces.
Overheating in the motors may destroy the windings and bearings, and demagnetize the
permanent magnets.
Only operate the motors with effective temperature control!
6
Low Voltage Directive
EC-regulation for machines, appendix II, letter B
(Declaration of manufacturer)
EC regulation for EMC
ATEX 100a
Dismantling motors is strictly forbidden.
All repair and service work will be done exclusive by the
manufacturer.
For the operation the internal PTC (DIN 44082) must be connected to
an external and valided cut-off device.
ENGLISH
DANGER
WARNING
610.40068.01 Siemens AG