Bowflex ElitePlus Assembly Instructions Manual page 5

Step 1 - Attach the Lower Lat Tower to the Base
Platform
Locate the following items:
• Item #1 - Lower Lat Tower
• Item #2 - Base Platform
• Item #H - (4) 3/8" X 3" Button Head Screws
• Item #N - (8) 3/8" Washers
• Item #O - (4) 3/8" Nylock Nuts
Set the Base Platform (Item #2) onto the floor as shown in
Figure 1. Line up the bolt holes in the mounting channels
on the Lower Lat Tower (Item #1) with the holes in the
Base Platform tubes.
Place (4) 3/8" Washers (Item #N) over the ends of (4) 3/8" X
3" Button Head Screws (Item #H) - one washer per screw.
Insert the forward screws through the bolt holes in the Lower
Lat Tower and Base Platform first, then tip the Base Platform
back to install rear screws. Place (4) 3/8" Washers over the ends
of the screws, one washer per screw, and secure using (4) 3/8"
Nylock Nuts (Item #O), as shown in Figure 1.
Completely tighten hardware installed during Step 1.
A-3