Advertisement
3. Adjust the pan/tilt/rotate angles of the camera by loosen the Pan/Tilt/Rotate
screws using the supplied Hexagon Wrench.
4. Connect the camera to power. You can either connect the camera to a 12VDC
power source or to a PoE switch using the PoE cable.
5. Connect the camera to the network using the supplied Cable Gland Kit. Please
refer to Step 6 in 3.1 EHN Series.
6. Now you can access the camera live view. See 4. Accessing the Camera.
4. Accessing the Camera
You can look up the IP address of the IP camera using the IP Utility (IPU)
program, which is included in the software CD.
The default network is DHCP. However, if there is no dynamic IP address
assigned to the device, its IP will switch to 192.168.0.10. By default, the ID is
admin and there is no password. Please input a password for the first-time login.
5. Important Note for Motorized Lens Models
For motorized lens models, if you find the live image out of
focus, please try the instructions below:
1. Go to the Live page and open the Lens Control panel
(see image on the right).
2. Click the Restore button for the lens to restore to the
default position, and then click the Auto Focus button.
3. If the image is still out of focus, adjust the focus by
clicking the Focus "+" or "-" buttons.
* Motorized Lens Models: EHN1250/2550/2850/ 2850-15;
EZN1250/2550/2850/2850-15
Rotate Screws (both sides)
Tilt Screw
Pan Screw
7
Version: E1
Advertisement
