Advertisement
7. Before screwing back the camera cover, remove the 3 old desiccant bags from
the inside of Camera Cover and replace them with the supplied Desiccant Bag.
Screw the camera cover back to the camera.
Remove the 3 desiccant bags
8. Now you can access the camera live view. See 4. Accessing the Camera.
3.2 EZN Series
1. Optionally insert a micro SD card into the card slot on the rear panel of the
camera. To do this, unscrew the 2 screw, remove the SD card slot cover and
then insert the micro SD card.
2. Drill three holes on the surface according to the screw positions on the
Camera Base. Push the supplied 3 Screw Anchors into the holes. Drill another
hole in the middle within the 3 screw holes if you wish to run the wires into
the surface. Screw the camera to surface using the supplied 3 Screws.
Stick the supplied desiccant bag
Screw
Screw Anchor
6
Note: Please screw back the
Camera Cover immediately
in case of reducing the
absorption capacity of the
desiccant bag inside the
camera body.
Surface
Advertisement
