Advertisement
Reset Button
The Reset Button can be used to restore the camera to factory default. When
the camera is powered up, press the Reset Button about 8 seconds to reboot the
camera.
3. Installation
3.1 EHN Series
1. Stick the supplied Mounting Sticker on the surface to mark the 4 screw
positions. Drill the 4 screw-depth holes on the surface and then push the
supplied 4 Screw Anchors into the screw holes. Optionally drill the bottom 2
Cable Holes if you want to run the cables through the surface.
+
+
+
2. Remove the camera cover by unscrewing the 3 cover screws using the
supplied Torx Wrench (Left Image). Screw the camera base to the surface
using the supplied 4 Screws (Right Image).
Screw Position x 4
+
Optionally drill the 2 Cable Holes if
+
you want to run the cables through
+
the surface.
4
Advertisement
