Table of Contents
Advertisement
INSTALLATION
Location
•
Do not install on outside wall.
•
Do not install in areas with direct heat source.
•
Do not install near any air discharge grill.
•
Do not install in areas exposed to direct sunlight.
•
Ensure room controller has sufficient air
circulation.
•
Ensure wall surface is flat and clean.
Installation
1. Remove security screw on bottom of room
controller cover (if applicable).
2. Open unit by pulling on bottom side of room
controller (see Figure 1).
FIGURE 1
Open Cover
3. Read FCC ID and IC label installed in cover before
installing any wireless product.
4. Ensure correct side of base faces up.
5. Pull cables 6" (15 cm) out from wall.
6. Align base and mark location of two mounting
holes on wall (see Figure 2).
Manual 2100-680
Page
6 of 18
FIGURE 2
Install Base
7. Install anchors in wall.
8. Insert cable in central hole of base.
9. Insert screws in mounting holes on each side of
base.
10. Strip each wire 1/4" (0.6 cm) from end.
11. Insert each wire and screw according to wiring
chart (see page 4).
12. Gently push excess wiring back into hole.
13. Insulate hole to prevent draft.
14. Gently align cover to top of base and snap in place
from bottom (see Figure 3).
FIGURE 3
Re-Install Cover
15. Install security screw.
Hide quick links:
Advertisement
Table of Contents
