1
m–6062
Figure 1
1. Mower
2. Chain
3. Chain Bolt
4. Push Arm
Before Installation
1. Tip mower upside down and block up ends to ease
installation of components.
2. Thoroughly clean the mower. All debris must be
removed to ensure baffles will fit properly against the
mower.
3. Repair all bent or damaged areas of mower and
replace any missing parts.
Warning
Contact with sharp blade can cause serious
personal injury.
Wear gloves or wrap sharp edges of the
blade with a rag.
Removing the Cutting
Chamber Stiffener
Note: This section is only for mowers with a stiffener
welded to the cutting chamber (Fig. 2).
1. Remove the cutting chamber stiffener from the mower
(Fig. 2).
4
6
7
5
2
3
5. Push Arm Bolt
6. Push Arm Nut
7. Push Arm Pin
2. Grind the welds flat on rear part of the chamber. This
will allow the correct fit for the cutting chamber
baffle.
1
2
Figure 2
1. Cutting chamber
Installing the Mower Baffles
Note: Use figure 3 for an overall view of where to install
the baffles.
5
m–5932
Figure 3
1. Front tunnel baffle
2. Rear tunnel baffle
3. Front of mower
2
m–6081
2. Cutting chamber stiffener
3
1
4
2
4. Center tunnel baffle
5. Cutting chamber baffle