Natim - Set No Answer Time; Ocseq - Set Outside Call Sequence; Page - Page - Avaya 2420 User Manual

2420 User Guide

NATim - Set No Answer Time

Sets the extension's no answer time after which ringing calls are forwarded or go to voicemail.
This function requires the time in seconds to be entered when programmed. The value is shown next to
NATim. This function cannot be programmed through the phone by the user.
Pressing NATim sets the extension's busy wrap up time to the indicated number of seconds. This
time is used to set a delay between ending one call and the next call ringing the extension (the waiting
call may be indicated on the display however).
•
[User | Digital Telephony | Advanced | Set | Set No Answer Time]
See also:
• WUTim - Set Wrap Up Time.

OCSeq - Set Outside Call Sequence

Sets the ringing pattern (sequence) used for internal calls. Not supported by the 2420.
This function requires the ringing pattern (0 to 9) to be entered when programmed. The number is shown
next to OCSeq. This function cannot be programmed through the phone by the user.
Pressing OCSeq changes the extension's ringback ringing pattern.
•
[User | Digital Telephony | Advanced | Set | Set Outside Call Seq]
See also:
• ICSeq - Set Inside Call Sequence.
•
RBSeq - Set Ringback Sequence.

Page - Page

Page the specified target extension or group. The target must be capable of hands-free speech.
This function requires the target extension or group number to be specified when programmed. The
target is then shown next to
user.
•
[User | Digital Telephony | Advanced | Dial | Dial Paging]
See also:
• GrpPg - Group Paging (!).
2420 User Guide
IP Office 3.0(DT)
Page. This function cannot be programmed through the phone by the
40DHB0002USEG Issue 3d (16th March 2005)
Page 48