Advertisement
BEFORE INSTALLATION
A. Protect the Bath Unit
Cover the bath with a protective layer or similar
material. Be careful not to scratch the bath surface.
INSTALL THE BATH
A. Put the bath at desired position
1. Adjust the feet under the bath to make it level. Adjust
the height of the bath to the height marked in the
Roughing-In. Tighten the nut on the adjustable feet
to settle the height of the bath.
IMPORTANT:
!
The bath must be installed level on a flat and level
subfloor without any bumps or protrusions.
!
Adjust the height of the bath to the height marked in
the Roughing-In.
2. Place the base on the floor.
3. Fix the base on the floor with silicone sealant.
4. Apply silicone sealant around the tail end of the
drain hose. Connect the drain hose with floor drain.
Make sure the drain hose protrudes from the floor for
a certain length to facilitate future bath removal.
5. Connect cold and hot supplies and check all
connections for leak.
1119528-T01-C
A.
A.
1.
!
!
2.
3.
4.
5.
-3-
Advertisement
