Siemens SIMATIC KP400 Comfort Operating Instructions Manual page 114

Commissioning the device
4.4 Configuring the device
Procedure
Proceed as follows:
1. Open the "Transfer Settings" dialog with the Transfer Settings icon.
2. Open the "Channel" tab.
3. To release the data channels of the HMI device, select "Enable Transfer".
4. To enable automatic transfer, select "Remote Control".
5. Configure at least one data channel:
6. Confirm your entries with "OK".
Result
The data channel is configured.
See also
Changing MPI/PROFIBUS DP settings (Page 115)
Changing the network configuration (Page 119)
Reference for functions (Page 79)
114
– Select the data channel.
– Configure the data channel using "Properties...".
Note: The "USB device" data channel has no configurable properties.
Operating Instructions, 03/2012, A5E03404994-02
Comfort Panels