Legal Notices; Product Name; Fcc (Federal Communications Commission); Laser Safety - Canon imageRunner Advance 400iF Starter Manual

Legal Notices

Product Name

Safety regulations require the product's name to be
registered. In some regions where this product is sold,
the following name(s) in parenthesis may be registered
instead.
• imageRUNNER ADVANCE 500iF/400iF (F190400)
FCC (Federal Communications
Commission)
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate, radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
OFF and ON, the user is encouraged to try to correct
the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment to an outlet on a circuit
different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV
technician for help.
Use of shielded cables are required to comply with
Class B limits in Subpart B of Part 15 of the FCC Rules.
Do not make any changes or modifications to the
equipment unless otherwise specified in this manual. If
you make such changes or modifications, you could be
required to stop operation of the equipment.
If your equipment malfunctions, please contact your
local authorized Canon dealer from whom you
purchased the equipment (if under warranty), or with
whom you have a servicing contact. If you are not sure
who to contact, and have both purchased and are
using the equipment in the U.S.A., please refer to the
"SUPPORT" page on Canon U.S.A. ' s Web site (http://
www.usa.canon.com).
Canon U.S.A., Inc.
One Canon Plaza, Lake Success, NY 11042, U.S.A.
TEL No. 1-800-OK-CANON

Laser Safety

This product complies with 21 CFR Chapter 1
Subchapter J as a Class I laser product under the U.S.
Department of Health and Human Services (DHHS)
Radiation Performance Standard according to the
Radiation Control for Health and Safety Act of 1968.
Also, this product is certified as a Class 1 laser product
under IEC60825-1: 2007. This means that the product
does not produce hazardous laser radiation.
Since radiation emitted inside the product is
completely confined within protective housings and
external covers, the laser beam cannot escape from the
machine during any phase of user operation. Do not
remove protective housings or external covers, except
as directed by the equipment's manual.
The label shown below is attached to the paper
drawer's right cover and toner supply port cover.
Use of controls, adjustments, or performance of
procedures other than those specified in the
manuals for this machine may result in
hazardous radiation exposure .
71