Chicco oasys 2/3 EVO Instructions Manual page 31

"ADJUSTING THE WIDTH OF THE BACKREST").
5. T hread the diagonal car seat belt through
the diagonal belt guide (B). Check that the
belt guide (l) open/close button is firmly
closed; you must be able to see the white
reference line (Diag. 8).
6. C onnect the car safety belt by threading the
lap belt trough the red lap belt guides (F) un-
der the two armrests in line, and by threading
the diagonal belt under the armrest on the
side of the fastener buckle (Diag. 9).
7. P ull the diagonal car safety belt upwards, to
ensure the belt is taut and fitting properly
over the child's legs and chest; don't tighten
it too much!. (Diag. 10).
WARNING! Check that the car safety belt is
tight enough.
WARNING! Check that the car safety belt is not
twisted (Diag. 11).
WARNING! Check that the diagonal safety belt
fits correctly across the child's shoulder (Diag.
10) and does not press on the neck; adjust the
backrest accordingly (see paragraph "ADJUST-
ING THE HEIGHT OF THE BACKREST").
WARNING! Check that the car safety belt ad-
juster is behind the backrest of the car seat (or
at least aligned to it) (Diag. 5).
WARNING! Do not fit the car safety belt in any
way other than that indicated in these instruc-
tions! (Diag. 12).
WARNING! Check that the child is strapped
into the child car seat correctly so that he can-
not slide forwards.
Installing the child seat inside the vehicle
without the child inside
When the child is not travelling in the car, the
child car seat should be left secured by the ve-
hicle three-point safety belt, or stowed away in
the car boot. An unsecured child car seat may
be a source of danger for the other passengers
in the event of an accident or sudden braking.
How to remove the child from the child
car seat
Release the car belt buckle, accompanying
the belt as it retracts.
Removal of the child car seat
WARNING! Remove the child from the child
car seat before removing it.
1. Release the car safety belt.
2. U nthread the diagonal strap through the
guide, accompanying it as it retracts.
Installing and removing the cup holder
The child car seat has 2 inserts, one on the
right and one on the left of the side of the seat
where you can fit the cup holder whenever
you like.
To install the cup holder:
1. I nsert the cup holder into the relative guide
(Diag. 13).
2. P ress the cup holder downwards until it
clicks into place (Diag. 14).
WARNING! Do not place glass containers or
hot liquids on the cup holder as they could
harm the child.
To remove it:
1. P ress the lever on the back of the cup holder
and lift it upwards, out of the guide (Diag. 15).
The cup holder guides are fitted with a special
device that makes sure it always remains in a
horizontal position.
To rotate and position the cup holder:
1. P ress the lever on the back and rotate it to
the desired position.
Adjusting the height of the back rest
The height of the headrest can be adjusted
to 10 different positions to adapt the child car
seat to the height of the child.
Make sure the child's head is always well pro-
tected and the car diagonal safety belt is posi-
tioned properly on his shoulder.
When adjusting the height of the backrest,
check that the diagonal belt loop (B) is po-
sitioned at a maximum of 2 cm above the
child's shoulder (Diag. 16).
To make the adjustment:
1. U se one hand to press the child car seat
backrest height adjuster lever (L) located on
the back of the headrest (Diag. 17).
2. R aise/lower the backrest to adapt it to the
height of the child's shoulders (Diag. 18).
31