Table of Contents
Advertisement
Troubleshooting ALP Software
13
Troubleshooting ALP Software
13.1 ALP Does Not Detect The EVM
If the following window opens after starting the ALP software, double check the hardware setup.
It may also be that the USB2ANY driver is not installed. Check the device manager. There should be a
"HID-compliant device" under the "Human Interface Devices" as shown in
The software should start with only "DS90UB95x" in the "Devices" pull down menu. If there are more
devices then the software is most likely in demo mode. When the ALP is operating in demo mode there is
a "(Demo Mode)" indication in the lower left of the application status bar as shown in
36
DS90UB95x-Q1EVM Deserializer User's Guide
Figure 30. ALP No Devices Error
Figure 31. Windows 7, ALP USB2ANY Driver
Copyright © 2017–2019, Texas Instruments Incorporated
Figure
31.
Figure
32.
SNLU223A – August 2017 – Revised May 2019
Submit Documentation Feedback
www.ti.com
Advertisement
Table of Contents
