Table of Contents
Advertisement
Using ALP and DS90UB95x Profile
12.3 Registers Tab - Address 0x00 Expanded
By double clicking on the Address bar
or a single click on
can be expanded.
Any RW Type register can be written into by writing the hex value into the "Value:" box,
putting the pointer into the individual register bit(s) box by a left mouse click to put a check mark
(indicating a "1") or unchecking to remove the check mark (indicating a "0"). Click the "Apply" button to
write to the register, and "refresh" to see the new value of the selected (highlighted) register.
The box toggles on every mouse click.
12.3.1
Port Specific Registers
Certain registers in the DS90UB95x-Q1 are port specific and have two copies, one for each FPD-Link RX
port. The "Select RX Port" drop-down menu controls which port's registers are read. If the "Write All RX
Ports" box is checked, both ports' registers will be written to. If it is not checked, only the port indicated by
the drop-down menu will be written to. These controls set the value of register 0x4C, which is used to set
which port is being read and which port(s) are being written to.
22
DS90UB95x-Q1EVM Deserializer User's Guide
. Address 0x00 expanded reveals contents by bits. Any register address displayed
Figure 15. ALP Device ID Expanded
Copyright © 2017–2019, Texas Instruments Incorporated
SNLU223A – August 2017 – Revised May 2019
Submit Documentation Feedback
www.ti.com
or
Advertisement
Table of Contents
