Table of Contents
Advertisement
www.ti.com
6
Typical Connection and Test Equipment
The following is a list of typical test equipment that may be used to monitor the MIPI CSI-2 signals from
the DS90UB95x-Q1:
1. Logic Analyzer
2. Any SCOPE with a bandwidth of at least 4 GHz for observing differential signals.
3. UNH-IOL MIPI D-PHY Reference Termination Board (RTB)
4. UNH-IOL MIPI D-PHY/CSI/DSI Probing Board
5. UNH-IOL CSIGUI Tool
7
Termination Device
A termination device is required to properly monitor and measure the transmission of the MIPI DPHY
signals. The termination device should support the change of signals as it switches between LP and HS
modes. This can be provided by either a CSI-2 receiver or a dedicated dynamic termination board. The
recommended termination board is the UNH-IOL MIPI D-PHY Reference Termination Board (RTB).
8
Typical Test Setup
Figure 7
illustrates a typical test set up used to measure and evaluate DS90UB95x-Q1.
SNLU223A – August 2017 – Revised May 2019
Submit Documentation Feedback
Figure 7. Typical Test Setup for Evaluation
Copyright © 2017–2019, Texas Instruments Incorporated
Typical Connection and Test Equipment
DS90UB95x-Q1EVM Deserializer User's Guide
13
Advertisement
Table of Contents
