J-Web Basics - Juniper J Series Quick Start Manual

J-series Services Router Quick Start

J-Web Basics

10
J-Web Basics
The unit number is the logical interface number. IP addresses are configured on
the logical interface. Setting the protocol family to inet specifies the routing
table of IPv4 addresses.
3. Set a default route (default gateway) for IPv4 packets. For example:
root# set routing-options static route 0.0.0.0/0 next-hop 10.1.1.50
4. Configure one or more static routes:
root# set routing-options static route destination-prefix next-hop address
5. Set the hostname. For example:
root# set system host-name Chicago
6. Save your configuration settings and activate them on the Services Router:
root# commit
For complete instructions, see the J-series Services Router Basic LAN and WAN Access
Configuration Guide.
The task bar at the top of the J-Web interface identifies the main J-Web functions.
You access specific tasks on the left.
Monitor—Output from common show commands
Configuration—Quick Configuration wizards and a graphical version of the CLI
Diagnose—Ping, traceroute, and packet capture
Manage—Configuration file management and licenses
Events—System log messages
Alarms—Active alarms
The first time you connect to a Services Router with the J-Web interface, you bypass
the login page and go directly to the Set Up Quick Configuration page. At
subsequent logins, you go directly to the System Monitor page.
Click Monitor to display information about the system (system serial number, CPU,
and memory usage), interfaces, configured routes, and other Services Router
functions.
Click Configuration to access Quick Configuration "wizard" pages for common
configuration tasks such as initial setup, certificate installation, basic routing setup,
and creation of firewall filters and IPSec tunnels. Each new release of the JUNOS
software adds more Quick Configuration features.