Juniper J Series Quick Start Manual page 7

Table 2: J-Web Set Up Quick Configuration (continued)
Field
Default Gateway
Loopback Address
fe-0/0/0 Address
Allow Telnet Access
Allow JUNOScript over
Clear-Text Access
Allow SSH Access
4. To configure additional interfaces:
a. Under Quick Configuration, click Interfaces, and then click the interface
you want to configure—for example, fe-0/0/1 .
b. On the Interfaces page, click Add to add a logical interface.
IP addresses are configured on the logical interface.
c. In the two boxes provided, type the IP address (for example, 192.168.1.1 )
and the number of bits in the subnet mask (for example, 24 ), click Add,
and then click OK or Apply.
To edit an existing interface, you click the logical interface.
5. To enable routing protocols, under Quick Configuration click Routing.
To add static routes, click Static Routing.
To enable a routing protocol, click the protocol.
When you are finished with a page, click OK or Apply.
For complete instructions, see the J-series Services Router Basic LAN and WAN Access
Configuration Guide.
Description
Default route. The IP address of a default router that the Services
Router can use to direct packets addressed to networks not
explicitly listed in the routing table.
Reserved IP address that is always available on the router. By
default, this address is set to
127.0.0.1/32
IP address and prefix length of the Ethernet management
interface. This address is set to
you must reset it now—to 10.1.1.1/24
Enables remote access to the router with Telnet.
Allows JUNOScript to send unencrypted text to the router over a
TCP connection.
Enables remote SSH access to the router.
Basic Connection and Configuration with the J-Web Interface
J-series Services Router Quick Start
.
at the factory, but
192.168.1.1/24
, for example.
7