Using The Web Interface; Access The Web Interface - Crestron DM Lite HD(I)-MD Series Supplemental Manual

Using the Web Interface

The web interface of the switchers allows configuration of routing, input, output,
network, and device settings. In addition, information about the switchers and the
connected display can be viewed.
NOTE: Configuration of the switchers is hosted by the receiver (HD-RX-201-C-E).
This section provides instructions to perform the following tasks:

Access the web interface

•
Navigate the web interface
•
View status information
•
Route an input to the HDMI output
•
Configure input settings
•
Configure output settings
•
Configure network settings
•
Configure device settings
•
NOTE: Unless otherwise indicated in this manual, the web pages of the switchers are
the same.
Access the Web Interface
To access the web interface:
1. Find the IP address of the switcher by pressing the SETUP button on the receiver
and noting the IP address on the connected display. The IP address is displayed
for 10 seconds.
NOTE:
transmitter also displays the IP address.
2. Open a web browser.
3. Go to the IP address. The Login page opens.
Supplemental Guide – DOC. 7797D
If the transmitter includes a SETUP button, pressing the button on the
DM Lite HD(I)-MD Auto-Switchers and Extenders • 5