Configure Automatic Power Settings - Crestron DM Lite HD(I)-MD Series Supplemental Manual

4. In the HDCP Enabled drop-down list, select either of the following:
Automatic: (Default setting) Specifies that the output be encrypted if the
•
input requires HDCP protection
Always Enabled: Specifies that the output always be encrypted regardless of
•
the input requirements

Configure Automatic Power Settings

Configure automatic power-off and power-on settings in the Automatic Power Settings
section of the Output page.
Output Page - Automatic Power Settings
By default, automatic power-off and power-on settings are disabled (the Disable radio
button is selected). To enable automatic power settings, click the Enable radio button.
For configuration information, refer to "Configure Power-Off Settings" and
"Configuring Power-On Settings" that follow.
Configure Power-Off Settings
If Automatic Power Settings is set to Enable, configure automatic power-off settings
by doing the following in the Power Off section:
1. In the Timeout drop-down list, select the amount of time in seconds that no
signal is active before the HDMI output automatically turns off. Available values
are the following: 5 seconds, 10 seconds, 15 seconds, 30 seconds, 60 seconds,
90 seconds, and Custom...(sec). The default setting is 5 seconds.
If Custom...(sec) is selected, enter the desired number of seconds in the Timeout
text box. Valid values range from 5 to 9999 seconds. To save the setting, click Set.
2. Specify whether the HDMI output is to be turned off according to the timeout
value specified in step 1. Select the Yes radio button to turn off the output or the
No radio button to allow the output to remain turned on.
Supplemental Guide – DOC. 7797D DM Lite HD(I)-MD Auto-Switchers and Extenders • 17