Configure Ir Settings - Crestron DM Lite HD(I)-MD Series Supplemental Manual

To configure RS232 port settings:
1. In the Baud drop-down list, select the number of bits to be transmitted per
second. Available values are as follows:
300
600
1200
2400
3600
4800
7200
The default setting is 9600 bits per second (bps).
2. In the Data Bits drop-down list, select the number of data bits that are to be
transmitted as a series. Available values are 7 and 8. The default setting is 8.
3. In the Parity drop-down list, select the parity. Available values are NONE, Odd,
Even, or Mark. The default setting is NONE.
4. In the Stop Bits drop-down list, select the number of stop bits. Available values
are 1 and 2. The default setting is 1.
5. In the Hardware Flow Control drop-down list, select the hardware flow control.
Available values are RTS/CTS and NONE. The default setting is NONE.
6. In the Software Flow Control drop-down list, select the software flow control.
Available values are NONE and XON/XOFF. The default setting is NONE.

Configure IR Settings

An IR file (*.ir) can be loaded to a switcher. The IR file defines all IR signals available on
the device.
NOTE: After the Crestron Database is installed on a PC, IR files are installed in the
following location on the PC:
C:\Program Files (x86)\Crestron\Cresdb\cresirdb.zip
Before loading an IR file, extract the *.ir files from the cresirdb.zip file.
Load an IR file using the IR Settings section of the Device page.
Supplemental Guide – DOC. 7797D
9600
14400
19200
28800
38400
57600
115200
DM Lite HD(I)-MD Auto-Switchers and Extenders • 27