Configure Analog Audio Settings - Crestron DM Lite HD(I)-MD Series Supplemental Manual

4. (Applicable only when Send command is set to IR) Do the following:
NOTE:
the switcher. For information about loading an IR file, refer to "Configure IR
Settings" on page 27.
a. In the IR drop-down list, select the IR signal that is to be transmitted to turn
on the output.
b. Continue with step 5.
5. (Applicable only when Send command is set to CEC, RS232, or IR) Do one of the
following:
Click Save to save the power-on settings.
•
Click Test to test the command. If the command is successful, click Save to
•
save the power-on settings.

Configure Analog Audio Settings

Configure analog audio settings in the Analog Audio Settings section of the Output
page.
Output Page - Analog Audio Settings
To configure analog audio settings:
1. Mute or unmute audio by clicking the Volume button, which is represented by a
speaker icon. By default, audio is unmuted and is set to 0 dB. When audio is
muted, the Volume button displays a red circle with a slash overlapping the
speaker icon (
2. (Applicable only when audio is unmuted) Adjust the volume as desired by
dragging the Volume slider to the left or to the right. The volume decreases when
the slider is dragged to the left and increases when the slider is dragged to the
right. Available values range from -80 dB to 20 dB.
20 • DM Lite HD(I)-MD Auto-Switchers and Extenders
In order for IR operation to be functional, an IR file (*.ir) must be loaded to
).
Supplemental Guide – DOC. 7797D